Ford Mondeo Mk3 Gniazdo Obd. Ford mondeo mk3, vikakoodi p0100 viesti kirjoittaja harhar » 14 maalis 2012 19:32 izio kirjoitti: Ghia15, i know where the port is:
Ford Mondeo MK3 20002007 obd port location YouTube from www.youtube.com
Top ford mondeo p0171 causes. 2015 ford mondeo iv sedan 1.5 tdci (120 hp) econetic 2014) and 10.6 l/100 km (22.19 mpg) (2002 ford mondeo ii wagon 3.0 v6 24v st220 (226 hp)), with variants from 2010 onwards being mostly on the lower end. The connector is on the left under the steering wheel.
A Proper Elm327 Should Communicate With Older Obd1 Type Interfaces, But May Depend On Type.
Ford mondeo mk3 2.0 pb 2002r. Obd monitor failed before a drive cycle was completed. Fuel economy varies between 3.6 l/100 km (65.34 mpg) (2014 ford mondeo iv 1.6 tdci (115 hp) econetic;
It Is Relatively Serious Problem Since It Leaves Your Vehicle In Failsafe Mode.
Here are the most common ones. P0301 should be considered a cause for concern, and can be a threat to the drivability the ford mondeo. Select the make of your car.
V6 2,5, Gasoline (168 Hp) 2001.
Please save fsl with sft/lft for obd and pcm (you will have to save 2 fsl, one for each module) and send to us (using pm or email address from conact us page of the site). I assumed that as mine was a facelift mk3 on an 04 plate it would be compatible, but looks like i was wrong. The connector is on the left under the steering wheel.
The One Nice Thing About P0301 Is That It Is A Cylinder Specific Misfire Code.
Post by rustin » fri oct 30, 2015 5:23 pm. Throttle pedal position sensor → switch (tps) a circuit range → performance problem. Open the cover, the plug is behind it.
Check That The Klavkarr Diagnostic Scanner Will Work With Your Car.
You can read their feedback on this page. It’s an obdii code and has to do with the throttle pedal position sensor. Ghia15, i know where the port is:
by 
